Running the Flexera Service Gateway 2 Installer

To install Flexera Service Gateway 2, perform the following steps.

note

By default, Flexera Service Gateway 2 is installed on the C drive. To install it to an alternate drive, you need to launch the installer using a command line, as described in Step 3 below.

The default username and password to connect to the Flexera Service Gateway 2 server are admin/Flexera! For more information, see Frequently Asked Questions.

To install Flexera Service Gateway 2:

1. Make sure that your server meets the requirements listed in System Requirements.

2. Download the Flexera Service Gateway 2 installer from the Flexera Software Product & License Center.

3. Launch the installer in one of the following ways:

   • To install Flexera Service Gateway 2 to the default directory, which is your Program Files (x86) directory, double-click the FlexeraServiceGateway2.exe file.

   • To install Flexera Service Gateway 2 to an alternate directory or drive, use the following command line syntax to launch the installer:

     FlexeraServiceGateway2.exe /V"INSTALLDIR=E:\MYDIRECTORY"

     where E:\MYDIRECTORY is the desired installation location.

   The Welcome panel of the Flexera Service Gateway 2 installer opens.

   

4. Click Next. The License Agreement panel opens.

   

5. Accept the license agreement and click Next. The Destination Folder panel opens.

   

6. If you want to install Flexera Service Gateway 2 in the specified directory, click Next. If you want to select a different directory, click Change, select a new directory, and then click Next. The Ready to Install the Program panel opens.

7. The Ready to Install the Program panel opens.

   

8. Click Install. The Installing Flexera Service Gateway 2 panel opens.

   

   When installation is complete, the InstallShield Wizard Completed panel opens.

   

9. Click Finish.

10. Proceed with the steps in Configuring and Using Flexera Service Gateway 2.